Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

I'm trying to model a tip penetrating a substrate

Posted May 12, 2011, 5:23 p.m. EDT 0 Replies

Luis Alvarez
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I'm trying to model an AFM tip indenting a substrate. However, my model deosn't seem to converge. I've checked the contact pairs as well as remeshing my model. I don't know where I'm going wrong. If someone could help me I would really appreciate it. My version of COMSOL is 3.4 a bit outdated but it should still work.

PS: I've attached a copy of my model if anyone can help me out I would really appreciate it.

Thank you

Attachments:

0 Replies Last Post May 12, 2011, 5:23 p.m. EDT
COMSOL Moderator

Hello Luis Alvarez

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content