F. Cipitì, L. Pino, A. Vita, M. Laganà, and V. Recupero
The paper presents a two-dimensional model to describe the gas flow in a propane autothermal reactor, developed at the CNR-ITAE Institute, and aimed to design a Beta 5 kWe hydrogen generator, named HYGen II, to be used with Polymer Electrolyte Fuel Cells (PEFCs) for residential applications. The main aim of the mathematical model was to optimize the reactor geometrical key parameters (diameter ...
Politecnico di Torino
In this paper, a model of a tubular fuel cell is proposed and includes thermo-fluid dynamics, chemical reactions and electrochemistry. The main results presented are the temperature distribution, the concentration of species and the polarization curves.
M.V. De Bonis[1,2], G. Altieri, and G. Ruocco[1,2]
 DITEC, Università degli studi della Basilicata, Potenza
Heat and mass transfer can be analyzed for conditions that may limit shelf-life. With this target, the purpose of the present work is the development of a general model which is applicable to a large variety of packaging configurations, food products and environmental conditions. To this end, COMSOL Multiphysics is exploited in a full 3D geometry.
Simulation of the Inverse Extrusion of Brass Rod by the Coupling of Fluid Mechanical, Thermal and ALE Modes
C. Mapelli, and L. Bergami
Dipartimento di Meccanica, Politecnico di Milano
The complete coupling among the Incompressible Navier-Stokes - General Heat Transfer -ALE modes can be a reliable tool for the simulation of the plastic deformation process. This is shown here.