Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Problem with 1-D Plotting

Please login with a confirmed email address before reporting spam

[SOLVED]

Hi. I have a problem. I created a 3D model of a mirror with a boundary heat source simulating incident laser beam. I'd like to plot the total displacement of a front surface of a mirror as a function of displacement along the z axis from center point.

Ive created 1D group in result section, added line graph, solid.disp [um] as y-axis, and z-axis [mm] as a x-axis and nothing happens. Im stuck here, because i tried (at least I think i did) everything. Any ideas, solutions?

1 Reply Last Post Oct 28, 2010, 9:40 a.m. EDT
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago Oct 28, 2010, 9:40 a.m. EDT
Hi

solid.disp so I assume V4 ?

have you triesd the Cut Line plots ? and are you sure you want disp and not just "w"
--
Good luck
Ivar
Hi solid.disp so I assume V4 ? have you triesd the Cut Line plots ? and are you sure you want disp and not just "w" -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.