Community > Discussion Forum > Step Function

Discussion Forum

Step Function

Topics: Step Function

Thread index  |  Previous thread  |  Next thread  |  Start a new discussion

RSS FeedRSS feed   |   Email notificationsTurn on email notifications   |   1 Reply   Last post: September 1, 2010 9:46pm UTC
Pekir Joseph

Pekir Joseph

September 1, 2010 2:59pm UTC

Step Function

Hi:


I want to multiply a voltage source from the electrical interface by a step function to cause a delay, how to go about
that?

Thanks

Reply  |  Reply with Quote  |  Send private message  |  Report Abuse

0 votes
Ivar Kjelberg

Ivar Kjelberg
Moderator

September 1, 2010 9:46pm UTC in response to Pekir Joseph

Re: Step Function

Hi

if I understand correctly your demand, I would propose to use the step function in V4 or a Heaviside (check the command.pdf doc) in V3.5 (they are the same in both versions, but they have been further implemented as clickable items in V4)
And then multiply your voltage amplitude by the step function, including a starting point (t-tau) and a rise time "DT" directly in the field where you need to define the voltage. (this applies to any variable by the way, not only to voltages)

--
Good luck
Ivar

Reply  |  Reply with Quote  |  Send private message  |  Report Abuse


Rules and guidelines